|
KOMPalox
Application
The microfiltration type KOMPalox is used for the
separation of oil, greases and fine particulates
from cleaning solutions. In this way, she adds
essentially to extend the service life of the inserted
process solution.
- Cleaning and decreasing solutions
- Grinding waste water and dispersion
- Waste water from automobile workshops and
transport services
Process Characteristics
The microfiltration is a physical separation
process. It separates aqueous dispersion and
emulsions. The medium to be separate flows along
a membrane with high rate and a specific
pressure.
The pore size of the membrane is dimensioned
that small molecules like water and solved
materials pass (permeate) and larger keep back
such as oils may be (retentate).
The filtrate flow is product dependent. The
separation process basically runs in the case of
recycling as during disposal. Depending on area of
application, the materials which are recovered are
contained either in permeate or in the retentate.
| Type |
1 |
2 |
| Filtrat flow l/hr |
25 |
50 |
| Membrane area ca. m² |
0,3 |
0,7 |
| Tank material |
1,4301 |
1,4301 |
| Required space |
|
| Length ca. mm |
1300 |
1300 |
| Width ca. mm |
600 |
600 |
| Height ca. mm |
1100 |
1100 |
| Overall height ca. mm |
1600 |
1600 |
Description of plant
The Kompalox plant consists of a sludge and oil separator as soon as a work and washing tank. The work tank is
subdivided into two chambers. In the first compartment the swimming oils, grease and deductible materials are
separated. The medium to be cleaned is sucked from the tank and pumped by the module.
Occurred during filtration through periodic moving pulses with compressed air and backwash with permeate that is
pressed by the membrane towards the filtration direction, a continuous cleaning of the membrane surface.
Emulsified oils, grease and solid materials are restrained by the module and are concentrated in the work tank .
The oil-free permeate is restored into the process bath again.
That concentrated oils and grease must from time to time be taken from the work tank.
Advantages
- Non polluting process
- Economically operation of the plant and cost savings through
recycling
- Completely preassembled and function tested
- Assembling costs at the installation site are minimal.
It occurred no production interruption.
- Compact, space-saving design simplified inserting
- The plant can be set up at any time at another place
- Minimal refill of the process baths because of the restoring of
active washing substances
- Wide range of application through variation of membrane types
- No temperature limits through the use of
stainless steel and ceramics
|
|
German
Contact
Print page 
Data sheet KOMPalox